Low Profile Switch X 1

This Switch has been selected because it is less than 2mm thick.

This means it will generally fit under most plastic gaming bases. It has nominal sizes of: 7mm x 5.5mm x 2mm. 

To attach the switch we recommend super glue or epoxy glue (be careful not to glue the switch in a fixed position).

Because the switch is so small you must be careful whilst soldering to avoid melting the switch. Or you could use our cold solder pen E-PEN01 instead.

To wire up connect 1 wire to the middle leg and 1 wire to either the left or the right leg it doesn’t matter which as this just decides which side turns it on or off.